WeatherFit Glendale Insulation CompanyWeatherFit Glendale Insulation Company

Open-cell foam insulation in Glendale CA - an attic that's sealed and safe

Upstairs too hot and the power bill climbing? We seal the attic under the roof and make sure the house stays safe once it's tight.

Request an estimate
Open-cell foam insulation coats the roof framing in an attic with a central HVAC unit and silver ducts.

Is open-cell spray foam right for my attic?

Open-cell foam insulation in Glendale is spray foam our crew puts on the underside of your roof, where it stops air leaks and insulates in one layer. That means ducts running through the attic end up inside the house's insulated space instead of baking up there all summer.

Most foam calls start with an upstairs that won't cool down, ducts running through a hot attic, or a new owner looking at old, flattened insulation in an older house. The price turns on how much roof area gets sprayed, whether old insulation has to come out first through insulation removal, and whether a furnace or water heater in the attic has to be dealt with before we start. The schedule depends on that prep and on how long you'll need to stay somewhere else. Your estimate lays out the work your attic needs and what it costs.

How we put in open-cell foam insulation

Foam under the roof changes how the whole attic works, so I start by looking at what's already up there, like the ducts, the boxes you store and any furnace or water heater. Once the plan is set, our crew covers what needs protecting and pulls out any old insulation that's soaked or full of droppings, because spraying over it leaves the problem in place. Then we spray open-cell foam onto the underside of the roof, all the way down to where it meets the walls, since that edge is where coverage usually comes up thin. After that, the attic is no longer vented to the outside and counts as part of the house. We trim the foam, clean up, and leave it ready for me to walk through with you.

Property managers call us for the same foam in offices and shops, and that work is on our commercial insulation page. If the floors downstairs stay cold because the space under the house is damp, a crawl space vapor barrier takes care of what attic foam can't reach.

Open-cell foam insulation in Glendale: what changes the job here

In Glendale, attic work follows the state building code plus the city's own changes to it. I check what that combined code asks of your attic before we spray, so the job is built to the rules Glendale uses.

Up near the foothills, and on streets where the house next door is a few feet away, sealing the attic has another benefit. National guidance finds that sealed, unvented attics are a good deal more fire safe in wildfire areas and between close neighbors, because ash and embers get into a regular attic through its vents. Many of the houses we see here are older, with ductwork running through a hot attic and insulation that's thin at the edges, and we see the same setup on jobs in La Crescenta-Montrose and Altadena.

Request an estimate

What happens after you call about open-cell foam in Glendale?

  1. Call and set a visit

    You call (747) 372-8156, and most of the time I pick up myself. We pick a time for me to come see the attic.

  2. I check the attic with you

    I go up with a flashlight and walk you through what I find, from the ducts to any furnace to the old insulation. Then I write up an estimate that covers the work your attic needs and what it costs.

  3. Our crew sprays the foam

    Our crew lead and installers do the work while you, the kids and the pets stay somewhere else. The questions below explain when it's safe to come back.

  4. We walk the finished attic

    I come back and look over the job with you before we pack up. If something isn't right, you tell me then and there.

Why Glendale homeowners call WeatherFit for open-cell foam

  • Learned in my dad's attics

    I grew up crawling through attics with my dad and started WeatherFit in 2021, so we've been at it 5 years. He taught me that insulation is the job nobody sees but the family lives with every day.

  • Licensed and insured, easy to check

    We're licensed and insured, and California's license board counts anyone putting in insulation for heat or sound control as an insulation contractor. You can look up any contractor, us included, on the state license board's lookup, which also shows complaint disclosures.

  • Told when foam isn't worth it

    Foam costs more because it seals and insulates at once. If your ducts don't live in the attic, attic air sealing plus a top-up of loose fill usually wins, and I'll tell you that straight so you pay only for what your house needs.

  • Based in Glendale, out to the valley

    We're based in Glendale and work the cities around it, from the foothills out across the San Gabriel Valley. Most of our calls come from older houses and new owners, so the attics we see here are familiar ground.

What matters most on this job is what's sharing the attic with the foam, and the only way to know is for me to go up and look, so call or send us a note to set that up.

Request an estimate

Get a written estimate for open-cell foam in your attic

Send the form, and we'll get back to you within one business day to set a time for me to come out. The estimate is free and done on site, and there's no pressure to book.

  • Licensed and insured.
Location
Glendale, CA 91206
Hours
Mon–Fri: 6 AM–11 PM, Sat–Sun: 7 AM–11 PM

Questions about open-cell foam in Glendale

Is open-cell spray foam cheaper than closed-cell?

Yes, open-cell usually costs less to install, mostly because closed-cell, the dense foam that blocks moisture, packs more material into the same space. If you want foam at a lower installed cost, pricing open-cell first is the sensible place to start. It still blocks air very well.

How much does spray foam insulation cost in Glendale?

Spray foam insulation in the Los Angeles area usually runs about $2 to $5 per square foot, and that's for spray foam in general, not open-cell alone. Where your attic lands depends on its size and the prep it needs, and your estimate gives you your own figure.

Do we have to leave the house during spray foam insulation, and for how long?

Yes. EPA guidance says everyone in the household, and any other trades working there, should be out while the foam goes in. You come back once the foam has cured and the house has been aired out and cleaned. Some makers recommend about 24 hours after a professional spray, but it varies, so ask which wait applies to the foam being used and plan a stay elsewhere for the kids and pets.

Can you spray foam an attic that has a furnace or water heater in it?

Not until that appliance is sorted out. One foam maker's retrofit guide says a conventional fuel-burning appliance can't run safely in a sealed attic, because it pulls the air it burns from the attic. I check for this at the estimate, and we deal with it before any foam goes up.

How do I keep an attic dry after open-cell foam goes in?

A sealed attic with no vents needs its own way to get rid of moisture, because open-cell foam stops air but lets water vapor pass through. Treat the moisture plan as part of the job and ask any installer how your attic will stay dry. I go over that at the estimate.

Can I still store things in my attic after spray foam?

Usually, but one foam maker's guide says foam in an attic used for storage needs a covering, such as drywall or an approved coating. Tell me at the estimate if you keep boxes up there, so the plan covers it.

  • Commercial insulation

    For property managers and owners who want an office, shop or rental building sealed and insulated the same way.

  • Crawl space vapor barrier

    When cold floors and a musty smell come from the ground under the house, not from the attic.

Have us check your attic for foam

When you call (747) 372-8156 or send the form, tell us the attic's rough size and whether ducts, a furnace or stored boxes are up there, so I know what to look for when I come out.

Request an estimateCall (747) 372-8156
(747) 372-8156Request an estimate